Golden Dream Catcher

Hi there, 

Today I'd like to share another card from the August Reveal using the Dream Catcher Maiden Set 865. 

I began by making the background for my maiden. I applied Nuvo Golden Crystal Glimmer Paste through the Dreamweaver Petit Fern stencil onto Kraft cardstock. This was set aside to dry.

The maiden image was stamped on to vellum with Versamark and then heat embossed with Gold Detail.

The image was colored with Copics from the back - this never looks very good! 

But when it is turned over to the front the colors are nice and muted. The image was then stuck down to a piece of sticker paper.

I fussy cut around the feathers at the bottom with my Tonic Mini Scissors and then used the Spellbinders Decagons die and had the feathers come over the bottom of the die.

The sentiment was stamped in Versamark and it was also embossed with Gold Detail. This was then cut out using Spellbinders Framed Tags One.

Indian Gold Embellishment Mousse was sponged on the background piece and around the edges of the sentiment.

To assemble the card I popped up the maiden on mounting tape. a piece of gold ribbon was attached to the sentiment and was wrapped around the back of the card front, leaving some of the feathers on top of the ribbon. The cardfront was layered to cream and then to a Kraft card base. Some Nuvo Golden Sunset Glitter Drops were added to the sentiment and beaded areas on the dream catcher.

 

... and that finished up my card for today. Hope you've enjoyed my share? The photo below shows the various dimensions of the different products.

Here is a list of the products used that you will find in the store:

Dream Catcher Maiden Set 865

Gold Detail Embossing Powder (EP168)

Versamark

Sticker Paper 99558

Nuvo Glimmer Shimmer Paste: Golden Crystal

Nuvo Glitter Drops Golden Sunset

Nuvo Embellishment Mousse Indian Gold

Tonic 5" Mini Scissors

I'd like to join in the following challenges with my card today:

Cardz 4 Galz: Get Krafty - Challenge 55: Use Kraft cardstock

Crafty Gals Corner Challenge 138: Anything Goes

World Wide Open Design Team Challenge Blog #25: Anything Goes

Scrapy Land (Challenge 72): Using any die cut that Scrapy Land Sells

Thanks so much for stopping by!

Shona

WINTER BIRDHOUSE

Hi there,

Today I'd like to share with you another card from the November Reveal. My card today uses the fun image Winter Birdhouse Stamp Set 803.

I decided to do a little spotlighting technique on my card. So to begin with I stamped the image twice with Memento Tuxedo Black on white cardstock and colored one of the images with Copic Markers: Y13, YR04, R17, E31, E33, E13, E35. I then used different sized punches (1", 1 1/4" and 1 1/2") to cut out the three little birds from the colored image. I then applied Dimensional Glue to the "snowy" parts of the circles. Twinkling Clouds was then applied to the glue and set aside to dry.

On the other black and white version, I applied the new Nuvo Moonstone Glimmer Paste with a paint brush to the patches of snow.

This piece, when dry, was cut out to 3 1/4" x 5 1/2" and was layered to a piece of cream cardstock which had been die cut with the Memory Box Cross Stitched Frame Borders and this was then layered to a black card base.

The little spotlit circles were attached with Foam Squares. The Nuvo Glitter Drops, White Blizzard and Silver Moondust were applied to the little dots around the image and Moonstone Glimmer Paste was applied to the little snowflakes.

That finishes my card for today. I'd like to enter this card in the following challenges:

Unicorn Challenge Blog: Challenge #15: Snow/Snowflakes

A Gem of a Challenge: #181 Snowflakes

Critters and Creatures Linky Party 9: November (Create an Outdoor Scene)

Till next time,

Big hugs,

Shona

SPARKLE N SPRINKLE'S NOVEMBER 1ST REVEAL

Hi there and welcome to the Sparkle N Sprinkle November 1st Reveal! I am the last Designer on Hop, so if you want to leave comments with all the designers and be eligible to win all the new sets, then go back to the beginning of the hop with Diane.  Today I am sharing a card made with a photo taken in my back yard last winter, the Winter Blue Jay Set 809 and some of the new Tonic Studios products, that are now available in the store.

We have seven new stamp sets to share with you today.  These new sets are 20% off until the 3rd of the month.  So once you finish the blog hop, head on over to the store and start shopping.  All of the new sets are available on cling mounted rubber or as a digital image.  

The sets are:

 Winter Birdhouse 803   (digi version DIGI803)

  Stella - Dear Santa 804   (digi version DIGI804)

   Christmas Tags #2 806   (digi version DIGI806)

Festive Lantern 808   (digi version DIGI808)

Winter Blue Jay 809   (digi version DIGI809)

Grumpy Goose 823    (digi version DIGI823)

Mr. Snowflake DIGI3127   (digi only)

On Nov 3rd, ONE GRAND PRIZE WINNER will be selected from the comments left on the Designers' blogs listed below. Please leave a comment with each Designer in order to be eligible for the Grand Prize.  You never know who the Mystery Designer will be that has the winning comment.

The Grand Prize Winner, which will be announced on the SNS Facebook page and on the SNS Blog, will receive ALL of the new stamp sets released this month (or the digi versions, if preferred).

The Blog Hop order this month is:

Diane

Anne

Eret

Chris

Belinda

Jess

Shona

(*Tip: if you have difficulty with a particular link, try clicking on the Designer's blog title to send you to their Home page.)

We hope you enjoy the New Reveal Blog Hop as much as we do.  Thanks for joining us and remember to comment on each of the Designers' blogs to be eligible for the Grand Prize.  

 Wonder who the Mystery Host will be this month????

The Sparkle N Sprinkle Creative Challenge also begins today.  There are lots of prizes and recognition badges.  Come check out how you can become a SNS Featured Artist as well.  The theme is always Anything Goes using Loose Glitter, Embossing Powder, and/or Flock.


Have you checked out the SNS YouTube Channel featuring Demo Donna?  If not, then you are in for a real treat.  Subscribe today to get all the latest Demo Donna tips and techniques!

So for my card today, I decided to use one of my photos that I had taken in the backyard last winter. A few glitters and some of the new Nuvo products, Crystal Drops and Glimmer Paste were used to make my sparkly winter scene.

I used the new Nuvo Fine Tip Glue Pen to apply my glitters over the snow on the branches, doing little sections at a time. Starting with Cloud Nine, then on to Lavender Iris.

Then to Starfire and finally Crystal Ice.

Midnight Blue Crystal Drops were then added to the photo to finish off the background.:

The image was stamped in Memento Tuxedo black, fussy cut and colored with Copics ((B24, B32, B34, C3, E13, E33) and then some Twinkling Clouds were applied to the branch with Brushable Glue.

Dimensional Glue was added to his eye. Glimmer Paste Blue Topaz was applied with a palette knife to his wing and tail.

The sentiment was stamped on white cardstock in Versamark and then heat embossed with one of the Tuscany embossing powders, Cerulean.  Memento Teal Zealand Danube Blue were sponged around the edges of the sentiment after it was cut out with the Lawn Fawn Stitched Label.

I made a bow with blue organdy ribbon. The bow was attached with the sentiment on Foam Squares as shown. This was then layered to a white card base edged with 1/4" Tear-ific Tape and the edges were applied with Denim Glitter.

The image was then attached with Foam Squares also, to finish up my card for today.

I'd like to enter my card in the following challenges:
Holly Jolly Christmas Challenge #84: Trees
Craft-Dee BowZ: November Challenge - Anything goes with a handmade bow
World Wide Open Design Team Challenge: Anything Goes

Hope you've enjoyed my share?

Big hugs,

Shona

OH CHRISTMAS TREE!

Hi there, 

Today I'd like to share my last SNS October Reveal card.  I used the Christmas Tree Tag from the Christmas Tags #1: Set 805.

I started with cutting out the Spellbinders Holiday Dies set, from different scrap pieces of green cardstocks and before removing the dies I sponged Memento Bamboo Leaves ink over the pieces, which gave each of the pieces a different two-toned look.

I stamped the Christmas Tree tag onto white cardstock in Versamark and heat embossed with Pear and cut out with the a Spellbinders Standard Circles die. I was aiming to give this card a monochromatic look, so each of the pieces were then daubed with Indian Gold Embellishment Mousse. I burnished extra onto the edges of the trees with my finger tool.

I made my background by using the big daubers to apply a piece of white cardstock with Lemon Sorbet and Spring Green Embellishment Mousses.

The background was layered to dark green before the white card base. The trees were then added overlapping one another using Tear-ific Tape and Foam Squares. The little orange star was punched from a scrap of orange cardstock which had been applied with some Moonstone Glimmer Paste.

The Nuvo Crystal Drops Bottle Green were applied to the top right corner as shown.

I hope you've enjoyed my monochromatic card today?

I'd like to join in the following challenges:

Shopping Our Stash #275: Three Trees

613 Avenue Create: #190: Use Green and Gold

World Wide Open Design Team Challenge #15: Anything Goes

Be back soon,

Shona

CHRISTMAS ELEPHANT IN THE WOODS!

Hi there, 

Today I'd like to share with you a card using the October Reveal Elephant Christmas Tree Set: 802 and the new Nuvo Glimmer Paste Moonstone.

I made my step card base using the Sizzix Balloons Step-Ups as a guide. I cut the inside panels from Super Adhesive sheets and stuck them on to the front panel and the two little steps. I repurposed the stamp by stamping the image on white cardstock in Memento Tuxedo Black and then I fussy the elephant and tree out, as I wanted him to be decorating his chosen tree out in the woods! I know elephants don't live in the woods, but call it artistic licence!

Our little friend was colored with Copics: YG03, YG06, YG67, Y17, R37, N2, C3, C5 and Dimensional Glue was applied to the baubles and the star, and to his hat and tail to which was added Twinkling Clouds Sparkle N Soft, for some dimensional sparkle. I die cut the trees with the Die-namites die cut Winter Forest and split it up so that it would fit on the steps of the card. The were sponged with Memento Olive Grove, Bamboo Leaves and Peanut Brittle and then once the inks were dry, I put them on a piece of left-over protective backing and applied the Moonstone Glimmer Paste with a spatula. I find that it is a very easy clean-up when you used the protective backing, none of the paste is wasted, just scoop up any paste from the sheet and put back in the jar. This was put aside to dry - though it doesn't take very long - half an hour at most.

I did the same process with the Memory Box Curved Merry Christmas, leaving "Merry" white.

The Glimmer Paste makes the piece very pliable.  When this was dry I stuck a piece of 3/4" Tear-ific Tape to the back of the "christmas" and burnished Cloud Nine to the word. The assembly of the card was next. I started with the steps, by removing the backing of the Super Adhesive Sheet scraps that I had put on the front of the steps. I then placed the two trees on the back step and then covered the remaining sticky surface with Cloud Nine Velvet Glitter. I repeated the process with the three trees and then placed the elephant on the front panel together with the Merry Christmas die. The Merry Christmas die was slightly wider than the card, so I turned it over and cut off the overlapping edges.

Here is a closer look at the dimension achieved with the Dimensional Glue.

I'd like to join in the following Challenges:

The Merry Christmas Challenge #2: Add a sentiment

Fashionable Stamping Challenge #116: Trees

Scrapy Land Challenge #51: Use a die cut brand that Scrapy Land sells

Cardz for Galz Challenge #33: Use at least one die cut

Hope you've enjoyed my share today and that I have inspired you to look at your stamps a wee bit differently.

Hugs,

Shona